The engine will not start even though the starter motor operates normally.
One of the following may be the cause of the problem:
Refuel the vehicle.
Try to restart the engine again following correct starting procedures.
The starter motor turns over slowly, the interior lights and headlights are dim, or the horn does not sound or sounds at a low volume.
One of the following may be the cause of the problem:
The starter motor does not turn over
The engine starting system may be malfunctioning due to an electrical problem such as electronic key battery depletion or a blown fuse.
However, an interim measure is available to start the engine.
The starter motor does not turn over, the interior lights and headlights do not turn on, or the horn does not sound.
One of the following may be the cause of the problem:
Contact your Toyota dealer if the problem cannot be repaired, or if repair procedures are unknown.
Emergency start function
When the engine does not start, the following steps can be used as an interim measure to start the engine if the engine switch is functioning normally:
1. Set the parking brake.
2. Shift the shift lever to P.
3. Turn the engine switch to ACCESSORY mode.
4. Press and hold the engine switch for about 15 seconds while depressing the brake pedal firmly.
Even if the engine can be started using the above steps, the system may be malfunctioning. Have the vehicle inspected by your Toyota dealer.
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Electronically Controlled Brake System(for Hv Model): Steering Angle Sensor Internal Circuit (C1433). Steering Angle Sensor Output (C1434). Malfunction in Yaw Rate Sensor (C1436)
Steering Angle Sensor Internal Circuit (C1433) DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) outputs this DTC when it receives an internal malfunction signal from the steering angle sensor. DTC No. Detection Item INF Code DTC Detection Condition Trouble Area MIL Note ...